An outside tap is one of those small jobs that makes summer in Doncaster a lot easier — filling the paddling pool, rinsing the car, watering the garden without dragging a hose through the kitchen, or cleaning muddy boots after a walk out towards Sprotbrough. It's a quick job for a plumber, usually done in under an hour. But it isn't quite the "screw-on kit from the DIY shop" job the boxes make it look, because there are Water Regulations you're legally required to meet. This guide covers what an outside tap actually costs to have fitted in Doncaster in 2026, the rules that matter, and how we do it properly.
Yorkshire Green Heating is a Doncaster-based, Gas Safe registered (638592) family firm rated 9.82/10 across 600+ verified Checkatrade reviews — and outside taps are exactly the kind of tidy, done-right-first-time job we like.
How Much Does an Outside Tap Cost in Doncaster in 2026?
For a straightforward installation where the tap can go on an external wall close to an existing internal cold pipe, you're looking at a fixed, all-in price. As a 2026 guide for the Doncaster area:
| Job | Typical 2026 price (fitted) | Typical time |
|---|---|---|
| Standard outside tap (wall backs onto a cold supply) | £120 – £180 | Under 1 hour |
| Outside tap with a longer pipe run inside | £170 – £280 | 1 – 2 hours |
| Frost-protected / anti-freeze outside tap | £160 – £260 | 1 – 2 hours |
| Replace or relocate an existing outside tap | £90 – £180 | Under 1 hour |
| Hot & cold outside tap / garden supply (bespoke) | from £280 | Half day |
Every one of our outside taps includes an isolation valve inside (so you can turn it off and drain it for winter), a WRAS-approved double check valve for compliance, a quality frost-resistant bib tap, and a clean, sealed exit through the wall. The price only really moves when the tap needs to be a long way from the nearest cold pipe, or when you want it somewhere awkward — a detached garage, a spot round the back of the house, or fed all the way down the garden.
The Rule Everyone Forgets: You Legally Need a Double Check Valve
This is the bit the DIY kits gloss over. Under the Water Supply (Water Fittings) Regulations 1999, any outside tap must have a double check valve fitted to prevent "backflow" — water being siphoned back from a hosepipe into your drinking-water supply. Picture a hose left sitting in a bucket of soapy water, weedkiller or a pond: without a double check valve, a drop in mains pressure could pull that back into the pipes that feed your kitchen tap. That's why it's a legal requirement, not an optional extra.
Worth knowing: the cheap screw-on outside tap kits sold in DIY shops often don't include a compliant double check valve, and self-fitting one incorrectly can breach the Water Regs. A proper plumber-fitted tap includes the correct valve as standard and is done to regulation — which matters if you ever sell the house or your water company inspects.
What's Actually Involved in Fitting One
On a standard installation, here's what a proper job looks like:
- Find the best route. We locate the nearest internal cold-water pipe (often under the kitchen sink or in a utility) and pick a tap position that keeps the pipe run short and tidy.
- Isolate and tee in. We fit an isolation valve so the outside tap can be shut off and drained independently — essential for winter — then tee off the cold supply.
- Fit the double check valve. The WRAS-approved valve goes in to meet the Water Regs and protect your drinking water.
- Drill and seal the wall. A neat core through the brick, the tap mounted securely on a back-plate, and the hole sealed weather-tight so there's no draught or damp.
- Test. We pressure-test the joints, check for drips, and make sure it shuts off cleanly.
If you'd like the tap somewhere further from the supply — down the garden for an allotment bed, or over by a caravan or campervan — that's a longer pipe run and a bespoke quote, but it's very doable. It's the same skill set as any of our everyday plumbing work in Doncaster.
Don't Forget Winter: Frost Protection
Doncaster gets hard frosts, and an outside tap is the most exposed bit of plumbing you own. A tap left full of water over a freezing night can burst — and because the split is often on the pipe just inside the wall, the first you know about it is water pouring into the house when it thaws. Two ways to avoid it: fit an internal isolation valve (which we always do) so you can shut off and drain the tap each autumn, or choose a purpose-made frost-protected tap with a longer valve stem that closes off well inside the warm wall. If you want a fit-and-forget option, the frost-protected tap is worth the small extra.
While We're There: Other Quick Summer Jobs
An outside tap fitting is often a good moment to tick off other small plumbing jobs in one visit — a dripping garden or kitchen tap, low water pressure, a slow-filling toilet, or booking in a water softener to protect your boiler and appliances from Doncaster's hard water. And if summer is when you're planning bigger work, it's the ideal time for a bathroom installation or a walk-in shower conversion while the weather's on your side. For a sense of what small plumbing jobs cost, see our Doncaster plumbing repair cost guide.
Want an Outside Tap Fitted This Summer?
Fixed price, fully compliant with the Water Regs, frost-protected and usually done in under an hour. Serving Doncaster and every DN village.
Book Your Outside Tap